Transfer Power Pack; Re-Installation - Ricoh D131 Service Manual

4.8.5 TRANSFER POWER PACK

Remove:

Transfer belt unit
1. Wire ( x 1) [A] (all wire guides)
2. Ground terminal wire [B] (wire guide x 1)

This terminal wire does not disconnect from the power pack.

Loosen the two left screws of the transfer belt lift solenoid [C], and remove the top screw
[D] to free the ground terminal wire.
3. Transfer current terminal wire [E] (wire guides x 2)
4. Transfer power pack [F] (

Disconnect the two standoffs on the right edge of the power pack and remove.

Re-installation


Confirm that the left edge of the power pack is below the tabs on the left.

Confirm that the transfer current terminal wire is below the wire guides on the right.

Pass the ground terminal wire under the top connector of the solenoid bracket and tighten all
the screws of the solenoid bracket.

Make sure the wire is below all the wire guides at the top.
SM
p.4-64
x 1)
4-69
Transfer Belt Unit
D131/D132/D133