Service Program Mode
5.2.4 TO SWITCH TO THE COPY WINDOW FOR TEST PRINTING
1.
In the SP mode display, press Copy Window to switch to the copy operation screen when you
need to select paper for a test print.
2.
Use the copy window (copier mode) to select the appropriate settings (paper size, etc.) for the
test print.
3.
Press [Start] to execute the test print.
4.
Press SP Mode (highlighted) to return to the SP mode screen and repeat from step 1.
Using the SP Mode
SP command numbers can be entered directly (if you know the entire number) or the command
can be selected from the menus.
Direct Entry
SP5831 (Initial Setting Clear) an executable SP that initializes the User Tools settings, can be
executed immediately by just entering the numbers.
1.
Press [5] [8] [3] [1]
2.
Press [#].
3.
Press "Execute" on the touch panel.
If you know all seven digits of the SP code, enter the seven numbers and press Execute.However,
if you do not know all the numbers, enter only the first four numbers of the seven-digit SP and
press [#]. The display goes immediately to the first SP of that group. Then you can use the buttons
to browse to the desired selection.
D131/D132/D133
5-6
SM