Transfer Roller Cleaning Blade - Ricoh D131 Service Manual

4.8.3 TRANSFER ROLLER CLEANING BLADE

Remove:

Transfer belt unit

Disassemble the transfer belt unit
1. Transfer roller cleaning blade [A] (

Never remove the inner lock screws [B] of the transfer roller cleaning blade.

When re-assembling, make sure that the clamps [C] and [D] are arranged as shown
above to avoid contact with the release lever.

The transfer roller cleaning blade should always be replaced when the transfer belt is
replaced.

Never touch the edge of a new transfer roller cleaning blade. The edge of the blade
is dusted with setting powder. If the setting powder is removed accidentally, dust the
edge of the blade with toner. This is especially important when only the transfer roller
cleaning blade must be replaced without replacing the transfer roller.

Work carefully around the transfer power pack located inside the transfer belt unit,
especially when cleaning with a vacuum cleaner, to avoid damaging the power pack
with static electricity.
SM
p.4-64
p.4-64
x 2)
4-67
Transfer Belt Unit
D131/D132/D133