Installation - Ricoh D131 Service Manual

2.18.3 INSTALLATION

1. Remove these parts:
Rear upper cover (
Rear lower cover (
Controller box cover (
2. Remove the cover [A] of Slot B (
3. Install the Copier Connection Kit Board B328 [B] in Slot B and fasten it (
4. Connect the power repeater cable [C] to:
CN32 on the controller board
CN4 on the copy connector board
5. Reattach the controller box cover, rear upper and lower cover.
Repeat Steps 1 to 5 to install the connector kit on the second machine.
6. Connect the end of the interface cable [D] to the copy connector board.
7. Attach the ferrite cores [E] to both ends of the interface cable.
8. If and additional cable is required, connect the repeater hub [F] and cable [G].
9. Attach the appropriate decal [H] to each machine.
10. Attach the "Printer/Other Function" decal (or its equivalent symbol for EU) if the
printer/scanner option is installed.
-or-
Attach the "Other Function" decal (or its equivalent symbol for EU) if the printer/scanner
option is not installed.
11. Attach the other end of the connection cable to the copy connector board installed in the other
machine.
SM
x2)
x2)
x 13)
x 2).
2-99
Copy Connector Type 3260 (B328)
x 2).
D131/D132/D133