Unit Preference: Mm Or Inch - Printronix T2N series User Manual

Unit Preference: mm or inch

Figure 12 illustrates how unit selection operates. Based on "inch" or "mm" selection, applicable
parameter values within the Printer Configuration section (or other sections) will change
accordingly, measured in inches or millimeters. The unit of measure shown to the right of the
parameter values will also change accordingly. The Media/Sensor Tab is mostly affected by this
selection.
Figure 12. Unit of Measurement in mm or Inches
IMPORTANT: Upon changing the unit type, an automatic "Read" operation will start.
Temporary values modified by the user but not saved in the printer will be overwritten.
65