Printronix T2N series User Manual page 36

Figure 5. Obtaining Printer Status
Once the Configuration Utility identifies the fault, you can press the FEED Key on the printer to clear the
fault. See Fault Recovery on page 37 to resolve the issue.
For Calibration Error, Ribbon Err, Ribbon End Err, or Paper Jam errors, verify that the Media/Sensor
configuration is correct (see "Media/Sensor tab on page 69). Upload the configuration by doing a "Read"
operation. If the "Read" operation times out with a "Port Open Error" or "Data Transmission Error", the I/O
channel may be blocked with a host job. In this case, cancel the print job on the host, reboot the printer,
and then perform the "Read" operation again to upload the configuration.
When the configuration has been uploaded, verify it is correct or make changes as necessary and save
those changes in the printer using the "Set" operation. If the fault persists, refer to Fault Recovery on
page 37 to resolve the issue.
36