Printronix T2N series User Manual page 43

Label feeding is not stable
(skew) when printing.
Skip labels when printing.
The printing position on small
labels is incorrect.
The left side printout position is
incorrect.
Missing printing on the left or
right side of label.
Configuration Utility requests
password when communicating
with the printer.
Power and Error LEDs are
blinking fast.
Wrinkle problem.
Gray line on the blank label.
Irregular printing
The media guide does not touch
the edge of the media.

Label size is not specified
correctly.

Sensor sensitivity is not set
properly.

The media sensor is covered
with dust.

Media sensor sensitivity is
not set properly.

Label size is incorrect.

The parameter Shift Y in the
LCD menu is incorrect.

The vertical offset setting in
the driver is incorrect.
Wrong Label Width size setup.
Wrong Label Width size setup.
A password previously set from
the Configuration Utility is lost.
Power was switched OFF and
ON too quickly.

Printhead pressure is
incorrect.

Ribbon is incorrectly
installed.

Media is incorrectly installed.

Print density is incorrect.

Media feeding is incorrect.

The printhead is dirty.

The platen roller is dirty.

The printer is in Job Capture
mode.

The RS-232 is incorrect.
1. If the label is moving to the
right side, move the media
width guide to the left
(inboard).
2. If the label is moving to the
left side, move the media
width guide to the right
(outboard).
1. Ensure the label size is set
correctly.
2. Calibrate the sensor by Auto
Gap or Manual Gap options.
3. Clean the Gap/Black mark
sensor (refer to Chapter 4 on
page 47).
1. Recalibrate the sensor
sensitivity.
2. Set the correct Label Length
size and gap size.
3. If the Label Length is correct
use the Configuration Utility
to adjust Vert Image Shift.
Set the correct label size. If the
label size is correct, use the
Configuration Utility to adjust
"Horz Image Shift."
Set the correct label size.
Contact the Printronix Auto ID
Customer Support Center (page
121) to request help on unlocking
the printer.
Power off the printer and wait for
all LEDs to turn off. Power on the
printer again.
1. See page 44 for more
information on ribbon
wrinkles.
2. Set the density to achieve
good print quality.
3. Ensure the media width
guide just touches the
outside edge of the media.
1. Clean the printhead.
2. Clean the platen roller (refer
to Chapter 4 on page 47).
1. Turn the printer off and on to
exit Job Capture mode..
2. Reset the RS-232 setting.
43