Printronix T2N series User Manual page 89

Label Buf Size
This option allows you to set the label buffer size. The buffer is used to store the data from ^XA
up to ^XZ for command processing. The maximum size of the buffer cannot exceed the amount
of available memory in the system. If a value greater than the amount of memory available is
selected, the setting will revert to the original setting. The new buffer size only takes effect upon
power-up after saving the configuration using "Set".
The range is 360 KB to 3600 KB, and the factory default is 720 KB.
FB Width Adjust
The FB Width Adjust command allows the user to adjust (increase or decrease) the width of field
block from the field block command ^FB, so that the text line in the block can be broken at a
different word.
The range is from -100 to 100 dots. The factory default is 0 dots.
DG Command
This menu sets the format type to correctly process a command.

Graphic Format (factory default). The command is used in graphic format (outside of
^XA...^XZ).

Label Format. The command is used in label format (within ^XA..^XZ).
CI22 Command
This menu allows the user to select either Unicode printing or DBCS printing for CI22.

Unicode Data (factory default). The data are treated as straight Unicode data.

DBCS Data. The data are treated as DBCS data.
Ignore JU Cmd
This menu allows the ^JU Configuration Update command to be ignored.

Disable (factory default). Process the ^JU command.

Enable. Ignore the ^JU command.
Ignore LH Cmd
This menu allows the ^LH command to be ignored.

Disable (factory default). Process the ^LH command.

Enable. Ignore the ^LH command.
Ignore PR Cmd
This menu allows the ^PR Print Rate command to be ignored.

Disable (factory default). Use the print rate settings from the ^PR command in the
datastream.

Enable. Ignore the ^PR commands in the datastream, and use the front panel Print
Speed setting.
89