Printronix T2N series User Manual page 71

Horz Image Shift
This option specifies the amount to shift an image horizontally outboard (-) or inboard (+) for
precise positioning on the label. The actual width of the image is not affected by this parameter.
The allowable range is -1.00 to +1.00 inch.
The factory default value is 0.00 inches.
Vert Image Shift
This option specifies the amount to shift an image vertically up (-) toward the leading edge or
down (+) toward the trailing edge for precise positioning on the label. The actual height of the
image is not affected by this parameter. The allowable range is -1.00 inch to 12.80 inches.
The factory default value is 0.00 inches.
Paper Jam Distance
After completing a label, this option specifies the maximum distance to search for a gap or mark
before declaring a paper jam fault. The range is 2.00 to 999.00 inches. The recommended
distance is 1.5 times the label length of the installed media.
The default is 10 inches.
Tear Off Adjust
This option represents the distance to advance (+ shift) or pull back (– shift) the stop position of a
label when Tear-Off Strip, Peel-Off, or Cut Media Handling option is selected. New set values will
take effect on the next print job. The allowable range is -1.00 inches to + 0.2 inches, in .01 inch
increments.
The factory default is 0.00 inches.
Label Wait Time
When Media Handling is set to Tear-Off Strip, Label Wait Time specifies the number of seconds
after printing stops that the printer will wait before it advances media to the tear bar position.
When Media Handling is set to Continuous, Peel-Off or Cut, Label Wait Time has no effect.
However, when Media Handling is set to Cut, the distance set for Tear Off Adjust will be added to
each form when being presented to the cutter.
The range is 0.1 to 60.0 seconds, and the factory default is 0.1 second.
Mirror
This option will mirror any image when enabled. The mirror effect is such that the last column is
printed first and the first column is printed last. The options are as follows:

Disable (factory default). No mirroring takes place. The image prints normally.

Enable. The image effect is used.
Fault Reprint
This option determines how the printer handles data that was printing when an error occurred.

Disable (factory default). The printer will not reprint the label that was printing when the
error condition occurred.

Enable. The printer reprints the label that was printing when the error condition occurred.
71