Printronix T2N series User Manual page 83

Note: The difference between Var. Length and Var Dynamic Len is for example,
CREATE;NAME;0. If there are 10 dynamic fields defined in CREATE mode, but only three
dynamic fields are used in EXECUTE mode (for Var. Length), the label length will be based on
the longest printed element among the 10 dynamic field and the static element defined in
CREATE mode. For Var Dynamic Len, the label length will be based on the longest printed
element among the three fields defined in EXECUTE mode and the Static element defined in
CREATE mode.
Var Form Type

Add Nothing (factory default). When selected, no action is taken.

Add ;0. When selected, the form length ends at the longest printed element.
(Same as ∼CREATE;filename;0)

Add ;X. When selected, the form length is the same as the physical page length (the
Label Length menu under MEDIA SETUP). (Same as ∼CREATE;filename;X).
Var Form Adjust
This specifies an amount (in tenths of inches) to add to the length of variable-length forms.
Variable-length forms use a semicolon at the end of the CREATE command:
~CREATE;<FORMNAME>;0.
Forms Handling
This submenu allows the user to handle the form in the following ways:

Disable (factory default). No effect.

Auto Eject. Automatically moves to the next TOF if the form is in the middle of the page,
and then ejects a page by performing a form feed (FF).

Auto TOF. Automatically does a form feed (FF) to the next top of form if the form is in the
middle of the page.
Do FF at TOF
This submenu determines whether the printer, with media already set at the TOF (Top-of-Form)
position, will advance media to the next TOF position upon receipt of an FF command.

Enable (factory default). The printer will advance media from the present TOF position to
the next TOF position upon receipt of an FF command, causing a blank form.

Disable. The printer will not advance media from the present TOF position to the next
TOF position upon receipt of an FF command.
Ext Execute Copy

Disable (factory default). Dynamic data, overlay data, etc. are not allowed if the optional
Form Count parameter (number of forms to print) is specified as part of the Execute
command. (This setting is IGP-100 compatible.)

Enable. Dynamic data, overlay data, etc. are allowed within a form where the Form
Count parameter is specified in the Execute command. In this case, the same form is
printed for whatever the Form Count is. Incremental data is not incremented since the
printing page is the same. The overlay data is only printed with the first form and not on
subsequent forms, and each form is printed on a separate page.
83