Power Pins; Configuration - Kontron speedMOPSlcdCE User Manual

KONTRON

Power Pins

19.3
Every power pin on the two power connectors as well as on the PC/104 bus connectors is limited to
a maximum current of 1A per pin.
If a system using a speedMOPSlcdCE is only supplied from the two power connectors, the following
limitations apply:
Power
VCC (+5V)
+12V
-12V
-5V
GND
A system using the speedMOPSlcdCE also can be supplied from the PC/104 bus connectors. If only
those supply voltages pins are used, the following limitations apply:
Power
VCC (+5V)
+12V
-12V
-5V
GND
Modules on the PC/104 bus consuming a higher supply current must provide power supply through
an additional connector.
Note: The speedMOPSlcdCE is not a replacement for a backplane. Use all power pins
on the power connectors and on the PC/104 connectors for power supply to the
board, and also use all additional power connectors on additional I/O cards, if
your system exceeds the above limitations. It is not acceptable to use only the
power pins of the PC/104 connector for power supply of the full PC/104 stack.

Configuration

19.4
The speedMOPSlcdCE is equipped with a power management system (APM). You can configure lots
of options for power-saving states such as standby state with partial power reduction and suspend
state with full-power reduction. You can specify wake-up events that bring the system back to full-
on state. Please refer to the "Power Menu" section in the "Appendix B: BIOS Operation" chapter.
speedMOPSlcdCE User's Guide
Number of Pins on both
power connectors
6
1
1
1
6
Number of pins on ISA
part
4
2
2
2
8
45
Max. Current
6A
1A
1A
1A
6A
Max. Current
4A
2A
2A
2A
8A
Power Interface