Option 11 - Text - ADEMCO Galaxy 16 Engineer's Manual

Option 11 – Text
This option is used by the engineer to assign a descriptor — of up to 16 alphanu-
meric characters — to the zones on the system.
When the Text option is selected,
descriptor. Press the ent key to select this zone or the A or B key to move to the
required zone and press the ent key.
Note: Pressing the appropriate number keys directly selects the zone.
The current descriptor of the selected zone is displayed on the top line of the
keypad and a section of the alphabet and numbers 7, 8 and 9 are displayed on the
bottom line.
The # key is used to toggle between the lower case alphanumeric characters,
upper case alphanumeric characters and library text. Refer to
.
LIBRARY
Note: On software versions V2.xx the Library has been removed from the Galaxy
16 plus, all text must be entered character by character. The Galaxy 16
retains its Library.
ZONE 1
_
789 ÅÄAÆ BCDEF G HI
Figure 5.15 Programming Text.
81
11 = Text
is displayed, along with its current
APPENDIX A: