Removing A Keypad From The System; Keypad Self Diagnostics; Keypad Operation; Number Keys - ADEMCO Galaxy 16 Engineer's Manual

4. Exit Engineer Mode by entering the Engineer Code and pressing esc:
the keypad displays the message
Press the esc key; the keypad display returns to the Unset Banner. If
this message is not displayed, the keypad is not communicating with
the control panel.
The keypad is now configured into the system.

Removing a Keypad from the System

A keypad can only be removed from an existing Galaxy 16 and 16 plus system
from Engineer Mode.
1. Access Engineer Mode from another keypad.
2. Disconnect the keypad to be removed from the system.
3. From the other keypad Exit Engineer Mode. The message
MISSING — [<],[>] to View
4. Press the A or B key.
The message
Ö
5. Press the
removed. The keypad returns to the unset banner.

Keypad Self Diagnostics

The Galaxy Mk III keypads have a self diagnostic feature that is used to test the
operational status of the inputs and outputs of the keypads.
The test is started by disconnecting the power from the keypad, then reapply-
ing the power while pressing the ent key. The test routine commences immedi-
ately. Each test last approximately five seconds. The test is terminated by
removing the power.
During the test the:
• Keypad address is displayed.
• Keypad buzzer is activated and a bell symbol is displayed.
• Power LED is illuminated and an a.c. and LED symbol are displayed.
• Keypad and keys are displayed. Each key press is confirmed by the
buzzer sounding and the key display being highlighted.

Keypad Operation

Number Keys

The number keys are used to enter the codes which identify the
1
2 3
users to the Galaxy control panel and permit access to the
system menu options.
4 5 6
7 8 9
0
Removing a Keypad
KEYPAD X — T=REMOVE MODULE
key to acknowledge and accept that the keypad has been
1 MOD. ADDED — esc=CONTINUE
is displayed
is displayed.
31
.
1 MOD.