Option 1 - Omit; Engineer Function; User Function; Normal Setting With Omitted Zones - ADEMCO Galaxy 16 Engineer's Manual

Option 1 - Omit

Engineer Function

The engineer uses the Omit option to enable the zones that can be omitted by
the user.
Note: The Engijneer Code can not omit zones, however it can be used to set the
system where zones have been previously omitted by a User code.
On selecting the Omit option, the omittable status of zone 01 is displayed. A
zone will be omittable when the square next to the zone number is black and
OMITTABLE appears on the bottom line of the display. press the # key or the
corresponding zone number keys (01 - 16) to toggle the omittable status of the
zone. Press the A or B key to view and select other zones.
Press the esc key to cancel the programming or ent to accept the selection.

User Function

The Omit option allows authorised users (see Option 4 - Codes) to set the
system with eligible zones omitted from the system, or to omit zones from the
system without setting. Omitted zones are reinstated automatically when the
system is unset or manually when the omit feature is disabled on the zones.
When the Omit option is selected zone 01is displayed along with its omit
eligibility and status:
•
If the bottom line reads NON OMITTABLE then the zone can not be
omitted, see Figure 5.4 (b).
•
If the top line shows a hollow square and the bottom line reads #,xx=OMIT,
where xx is the zone number, then the zone can be omitted, see Figure 5.4
(a).
•
If the top line shows a hollow square and the bottom line reads OMIT then
the zone has been omitted, see Figure 5.4 (c).
If the zone is omittable pressing the # key or the corresponding zone number
keys (01-16) toggles the omit status of the zone, the display indicates the omit
status. Press the A or B key to to view and select other zones.
Note: A zone is omitted from the system as soon as it is selected.
Pressing esc saves the Omit programming allowing the system to be set with
the omitted zones at a later time.
Pressing ent initiates the setting with the selected zones omitted.

Normal Setting With Omitted Zones

If zones have previously been omitted from the system, then, when the system
is set the omitted zones are bypassed. Set the system as normal, see Section 4:
Setting Options; the system starts to set and the display indicates how many
zones have been omitted. The zones remain omitted until the system is unset.
1 = Omit
48