Programming Codes Attributes - ADEMCO Galaxy 16 Engineer's Manual

4 = Codes (cont'd)
User Number (range: 1–14)

Programming Codes Attributes

When the Codes option is selected,
to view other users. Press ent to select the required user then press the # key to
access the code attributes— (user instruction only, the engineer cannot carry
out this operation).
The Set Access attribute is displayed along with its status. An attribute is
enabled when the square next to the attribute number is black and
appears on the bottom line of the display. To toggle the status of an attribute
press the # key. Press the A, B and # key to view and modify other attributes.
1 SET ACCESS
#, 1 = ENABLE
(a) Set Access disabled
Note: Pressing the attribute number key, (1 – 8 for the engineer, 1 – 7 for users),
directly toggles the enable status of the corresponding attributes.
When the required attributes have been assigned to the user, press the ent key
to save the selection or esc to cancel.
The display returns to the selected user number. Press the A or B key to view
the other users. To exit from the Codes option press the esc key.
Table 5.3 User Code Attributes lists the available Code Attributes and defaults.
Currently assigned code hidden.
> ÚÚÚÚ ( 0— 9999)
US R 1
Pressing the Ö key four
times deletes the digits in
the assigned code.
>— — — — ( 0— 9999)
US R 1
Once the code has been cleared press ent to
accept the programming or esc to cancel.
Figure 5.9 Deleting a User Code.
USR 1
# or 1 to toggle
Set Access status
Figure 5.10 Set Access Statuses.
54
Valid Code Range
is displayed, press the A or B keys
1 z z z z z SET ACCESS
ENABLED
(b) Set Access enabled
ENABLE