Receiver; Dial Type - ADEMCO Galaxy 16 Engineer's Manual

12 = Communications 1 (cont'd)
2. SIA 1
The SIA level 1 format is a protocol that transmits detailed point
identification (Point ID) information to a SIA compatible receiver. The
SIA level 1 format transmits alarm events, the activated zone number and
the type of event. The SIA format is capable of transmitting over 27 different
Galaxy event types.
3. Microtech
Microtech format is a protocol that transmits detailed point identification
(Point ID) information to a PC with Galaxy Alarm Monitoring installed.
The menu structure and programming of the Microtech option are identical
to the SIA option.
Note: When SIA 1 is selected, non alarm events are not transmitted while the
panel is being remotely serviced by Galaxy Gold. This allows the system
to be set, unset, or alarms cancelled, without the call being terminated.

05 Receiver

The transmission destination can be set to one of three modes:
1. Single:
reports to the telephone number programmed in Telephone Number 1.
2. Dual:
reports to both numbers programmed in Telephone Number 1 and
Telephone Number 2. The alarm must be transmitted to both numbers.
3. Alternative:
reports to Telephone Number 1 or Telephone Number 2. Each number is
tried in sequence until the alarm is successfully transmitted. The alarm is
only transmitted to one number.

06 Dial Type

The transmission mode can be selected from two types:
0. DTMF Dial:
(also known as "Tone") this is much quicker at dialling than the Loop
Disconnect option.
1. Loop Disconnect:
(also known as "Rotary" or "Pulse") is universal, however, an increasing
number of exchanges now provide the DTMF Dial option.
Note: Although this equipment can use either Loop Disc. or DTMF signalling
only the performance of DTMF signalling is subject to regulatory
requirements for correct operation. It is therefore recommended that the
equipment is set to use DTMF signalling for access to public or private
emergency services. DTMF signalling also provides faster call set up.
86