Monitor Stu Lf; Digi If Stu Fail; Stu Triggers - ADEMCO Galaxy 16 Engineer's Manual

13 = Communications 2 (cont'd)
The C/OP–Rem.Serv option overrides the other remote servicing options in
menu option 13.10 Access.
To enable the C/OP–Rem.Serv option press the # key until the top line of the
4zC/OP-Rem.Serv
, press the ent key to accept. To
keypad display reads
disable the C/OP–Rem.Serv option press the # key until the top line of the
4 C/OP-Rem.Serv
, press ent to accept.
keypad display reads
Note: It is strongly recommended that only one of the Control Output options is
enabled on a Galaxy 16 plus control panel at a time.

5 Monitor STU LF

This option, when enabled, will monitor pin 15 on the Header pins for activation
of the 3GSTU–PLI Line Fail output. It also enables monitoring of the Line-Fail
zone input terminal. Activation of this input to the control panel will cause the
Galaxy 16 plus Intruder outputs to activate.

6 Digi if STU Fail

This option, when enabled, will cause the on–board telecom module (digi) to
dial the programmed Telephone No with a Tamper (LT/LR – Line Trouble/Line
Restore) signal in the event of a line fail on the 3GSTU–PLI's phone line. This
option will only work if menu option 12.04 Format has been programmed as
SIA, the Tamper trigger in menu option 12.07 Triggers must also be enabled.

5 STU Triggers

The STU triggers option is used to assign triggers to the six alarm inputs on the
3GST–PLI. Triggers one to six activate Galaxy 16 plus output pins one to five
and sixteen respectively. The available triggers are shown in Table 6.5 STU
Triggers.
On selecting menu option 5 STU Triggers trigger 1 is displayed. To programme
this trigger press the . Enter the two digit trigger number corresponding to
ent
the trigger type required, see Table 6.5 STU Triggers. Press the key to
ent
accept or esc to cancel. Use the A , B and ent keys to view and select other
triggers.
97