Option 2 Chime - ADEMCO Galaxy 16 Engineer's Manual

2 = Chime

Option 2 Chime

The engineer function and user function of this menu option are identical. The
Chime option is used to select which zones are to operate in chime mode. Any
zone that is programmed to chime momentarily activates the horn output on the
panel and the keypad buzzers when opened. The chime emitted from the horn is
two-tone and operates on low volume.
When the Chime option is selected zone 01 is displayed along with its chime
status. The Chime status on a zone is disabled if the top line of the keypad
display shows a hollow square next to the zone number and the bottom line
reads
#, xx = OMIT,where xx is the zone number.The Chime status on a zone is
enabled if the top line shows a filled square and CHIME appears on the bottom
line of the display. This is illustrated in Figure 5.5 Chime Statuses.
Press the # key or the corresponding zone number keys (01 - 16) to toggle the
chime status of the zone. Press the A or B key to view and select other zones.
All zones default to Chime disabled.
Once the Chime status has been programmed on the required zones press the
ent key to accept the selection or esc to cancel.
04 INTRUDER
#, 04 = CHIME
(a) Zone 04 Chime disabled
# or 04 to toggle
omit status
Figure 5.5 Chime Statuses
50
z
04 INTRUDER
CHIME
(b) Zone 04 Chime enabled