Download Print this page

ADEMCO VISTA Manual

Via ad2usb interface to vera plus

Hide thumbs Also See for VISTA:

Download this manual

Ademco Vista Panel

Via AD2USB interface to Vera Plus

March 2020

Page 1 Ademco Vista Panel Via AD2USB interface to Vera Plus March 2020...
Page 2 You may need to set the AD2 devices mode and address. By default the AD2 device is factory configured for Ademco mode at address 18. If you already have a device at 18 or need to change to DSC mode you will need to change the AD2 settings.
Page 3 Install this Plug in...
Page 5 The AD2USB Plugin installs two devices above. I renamed them (shortened Ademco) since Vera Plus UI7 truncates names (UI5 didn’t care).
Page 6 This is the device for the panel The other is the device for the partition which is most used. No special settings here. Make note of device number (red circle) for Luup step later.
Page 7 This is the device for the partition Need to set keypadaddress to match panel setup and AD2USB config. In my case address number 01. This is the device most used as it is the keypad into the panel. This is the setup for USB port on Vera to talk to AD2USB.
Page 9 This is one line of LUUP code to suppress the “can’t connect error to” the panel device. I set it up as a scene to be run manually if the error shows up. I suppose you could maybe put it as a startup LUUP but I didn’t try that. It operates on the panel not the partition or device 126 in my case.