System Configuration; Connection With Plc - Mitsubishi Electric FX2N-10PG User Manual

Model FX2N-10PG Pulse Output Block
4.

System configuration

4.1

Connection with PLC

The PLC is connected to FX
FX -10PG is handled as a special unit of the PLC and is sequentially given the special unit
2N
number of 0 to 7 from the unit which is the nearest to PLC.
FROM/TO commands.)
For details of the input/output assignment of PLC, refer to the manual of each PLC.
• A maximum of 8 units can be connected to the FX
maximum of 4 units can be connected to the FX
• When connected to an FX
When connected to an FX
• For extension, the separately available FX
CNV-BC are used.
One extension cable can be used per system.
• The number of occupied I/O points of the FX
the basic unit, extension unit and extension block and the occupied points of the special
block must not exceed the max. Number of the I/O points of the basic unit.
• The assignment of the I/O number of the PLC is shown in the parentheses. The I/O
connectors and occupied points of FX
numbers of the PLC.
*1. Because the special unit No. 0 is assigned to the built-in CC-Link/LT master in the
FX
3UC
*2. A maximum of 7 units can be connected to the FX
Turn OFF the power at first, then connect/disconnect the cable such as an extension cable.
If you connect/disconnect a cable while the power is supplied, the unit may fail or malfunction.
-10PG with the extension cable.
2N
Series PLC, the FX
2NC
Series PLC, the FX
3UC
-32MT-LT(-2), unit numbers assigned to special units begin with No. 1.
*1
/FX
2N
Series PLC.
2NC
-CNV-IF is required.
2NC
-CNV-IF or FX
2NC
-65EC/FX -30EC extension cable and FX
0N 0N
-10PG is 8. The total number of I/O points of
2N
-10PG are not included during assignment of I/O
2N
-32MT-LT(-2) PLC.
3UC
System configuration 4
(The unit No. is instructed with
/FX *2 Series PLC and a
3U 3UC
-1PS-5V is required.
3UC
4-1
-
2N