Interrupt Stop Operation; Outline Of Interrupt Stop Operation; Operation Speed; Address Instruction - Mitsubishi Electric FX2N-10PG User Manual

Model FX2N-10PG Pulse Output Block
8.8

Interrupt stop operation

8.8.1

Outline of interrupt stop operation

START
Interrupt input (X0)
• Positioning operation
If START is input or START (BFM#26 b9) is turned ON when the interrupt stop operation
(BFM#27 b4) operation pattern is selected, the positioning operation is started at the
operation speed Ι (BFM#16, #15).
When the work arrives at target address Ι (BFM#14, #13) (deceleration stop) or the interrupt
is input (interrupt input X0 is the edge detection), it is decelerated and stopped with the
positioning ended.
8.8.2

Operation speed

The actual operation speed is expressed as [Actual operation speed = Operation speed Ι
(BFM#16, #15) × Override (BFM#21)].
Operation speed Ι can be changed at all times.
However, the operation speed can not be changed when the speed change disablement
(BFM#26 b10) during operation is ON.
8.8.3

Address instruction

Absolute address and relative address can be instructed with BFM#26 b8.
b8=OFF : Absolute address instruction (The travel is set as the distance from the address
value 0.)
b8=ON : Relative address instruction (The travel is set as the distance from the current
address.)
8.8.4

Rotation direction

Absolute address mode : The rotation direction is determined depending on the large/small
Relative address mode : The rotation direction is determined depending on the symbol
Deceleration time
(BFM#11)
Maximum speed
(BFM#1,#0)
Operation speed Ι
(BFM#16,#15)
relationship between the current address (BFM#25, #24) and target
address Ι (BFM#14, #13).
(positive/negative) of target address Ι.
Deceleration speed
(BFM#12)
Target address I
(BFM#14,#13)
Bias speed
(BFM#2)
Operation pattern 8
Time
8-21