Mitsubishi Electric FX2N-10PG User Manual page 20

Model FX2N-10PG Pulse Output Block
Cautions regarding installation
1) Use the block under the environmental conditions specified in the manual.
Do not use the unit in a location surrounded by dust, oil fumes, conductive dust, corrosive
gas or combustible gas, exposed to high temperature, condensation, wind or rain, or subject
to vibration or impact.
Use in such a location may cause an electric shock, fire hazard, malfunction, or breakage or
degradation of the product.
2) Before installation, wiring or similar work, be sure to switch off the external power supply to
isolate the block.
Otherwise, it may cause an electric shock or damage the product.
3) When turning on the power supply or operating the block after installation, wiring or similar
work, be sure to install the top cover.
4) When tapping a hole or routing a wire, prevent chips or wire chips from dropping into the
vent windows of FX
Such chips may cause a fire hazard or malfunction.
5) Securely fasten the extension cable to a specified connector.
If it is poorly connected, it will cause a malfunction.
-10PG.
2N
Installation 3
3-2