Add/Edit Trusted Radius Client; Cloudcnm Screen - ZyXEL Communications USG40 User Manual

43.12.1 Add/Edit Trusted RADIUS Client

Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add
icon or an Edit icon to display the following screen. Use this screen to create a new entry or edit an
existing one.
Figure 616 Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
Table 366 Configuration > System > Auth. Server > Add/Edit
LABEL
Activate
Profile Name
IP Address
Netmask
Secret
Description
OK
Cancel

43.13 CloudCNM Screen

CloudCNM is a cloud-based network management system that allows management and monitoring
of ZyWALL/USG/UAG security gateways with firmware that supports the TR-069 protocol.
In the following figure, SP is the management service provider, while A and B are sites with devices
being managed by SP.
Chapter 43 System
DESCRIPTION
Select this check box to make this profile active.
Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
Enter the IP address of the RADIUS client that is allowed to exchange messages with the
ZyWALL/USG.
Enter the subnet mask of the RADIUS client.
Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
ZyWALL/USG and the RADIUS client.
The key is not sent over the network. This key must be the same on the external
authentication server and the ZyWALL/USG.
Enter the description of each server, if any. You can use up to 60 printable ASCII
characters.
Click OK to save the changes.
Click Cancel to discard the changes.
ZyWALL/USG Series User's Guide
870