ZyXEL Communications USG40 User Manual page 345

Figure 243 Configuration > Network > Interface > VTI > Add
Each field is described in the table below.
Table 122 Configuration > Network > Interface > VTI > Add
LABEL DESCRIPTION
General Settings
Enable Select this to enable VTI. Clear this to disable it.
Interface Properties
Interface Name This field is read-only if you are editing an existing VPN tunnel interface. For a new VPN
tunnel interface, enter the name of the VPN tunnel interface in vtix format, where x is a
number from 0 to the maximum number of VPN connections allowed for this model. For
example, enter vti10.
Zone Select a zone. Make sure that the zone you select does not have traffic blocked by a
security feature such as a security policy.
vpn-rule You should have created a VPN tunnel first for a Vpn Tunnel Interface scenario.
Select one of the Vpn Tunnel Interface scenario rules that you created.
IP Address
Assignment
IP Address Enter the IP address for this interface.
Chapter 10 Interfaces
ZyWALL/USG Series User's Guide
345