ZyXEL Communications USG40 User Manual page 768

The following table describes the labels in this screen.
Table 308 IPv4 Address Configuration > Add/Edit
LABEL
Name
Address Type
IP Address
Starting IP
Address
Ending IP
Address
Network
Netmask
Interface
Country
OK
Cancel
42.6.2.2 IPv6 Address Add/Edit Screen
The Configuration > IPv6 Address Add/Edit screen allows you to create a new address or edit
an existing one. To access this screen, go to the Address screen (see
and click either the Add icon or an Edit icon in the IPv6 Address Configuration section.
Figure 526 IPv6 Address Configuration > Add/Edit
Chapter 42 Object
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET,
INTERFACE IP, INTERFACE SUBNET, INTERFACE GATEWAY and GEOGRAPHY.
Note: The ZyWALL/USG automatically updates address objects that are based on an
interface's IP address, subnet, or gateway if the interface's IP address settings
change. For example, if you change 1's IP address, the ZyWALL/USG automatically
updates the corresponding interface-based, LAN subnet address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the beginning of the range of IP addresses that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the end of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot
be blank. Enter the IP address of the network that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot
be blank. Enter the subnet mask of the network that this address object represents. Use
dotted decimal format.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the
Address Type, use this field to select the interface of the network that this address object
represents.
If you selected Geography as the Address Type, use this field to select a country.
Click OK to save your changes back to the ZyWALL/USG.
Click Cancel to exit this screen without saving your changes.
ZyWALL/USG Series User's Guide
768
Section 42.6.2 on page 766),