ZyXEL Communications USG40 User Manual page 49

Figure 25 Internet Access: PPPoE Encapsulation
2.1.3.1 ISP Parameters
• Type the PPPoE Service Name from your service provider. PPPoE uses a service name to identify
and reach the PPPoE server. You can use alphanumeric and -_@$./ characters, and it can be up
to 64 characters long.
• Authentication Type - Select an authentication protocol for outgoing connection requests.
Options are:
• CHAP/PAP - Your ZyWALL/USG accepts either CHAP or PAP when requested by the remote
node.
• CHAP - Your ZyWALL/USG accepts CHAP only.
• PAP - Your ZyWALL/USG accepts PAP only.
• MSCHAP - Your ZyWALL/USG accepts MSCHAP only.
• MSCHAP-V2 - Your ZyWALL/USG accepts MSCHAP-V2 only.
• Type the User Name given to you by your ISP. You can use alphanumeric and -_@$./ characters,
and it can be up to 31 characters long.
• Type the Password associated with the user name. Use up to 64 ASCII characters except the []
and ?. This field can be blank.
• Select Nailed-Up if you do not want the connection to time out. Otherwise, type the Idle
Timeout in seconds that elapses before the router automatically disconnects from the PPPoE
server.
2.1.3.2 WAN IP Address Assignments
• WAN Interface: This is the name of the interface that will connect with your ISP.
• Zone: This is the security zone to which this interface and Internet connection will belong.
• IP Address: Enter your (static) public IP address. Auto displays if you selected Auto as the IP
Address Assignment in the previous screen.
Chapter 2 Installation Setup Wizard
ZyWALL/USG Series User's Guide
49