View Ap Log - ZyXEL Communications USG40 User Manual

Table 78 Monitor > Log > View Log (continued)
LABEL
Message
Source Address
Destination Address
Source Interface
Destination Interface
Protocol
Search
Email Log Now
Refresh
Clear Log
#
Time
Priority
Source
Destination
Note

7.26.2 View AP Log

Click on Monitor > Log > View AP Log to open the following screen.
Chapter 7 Monitor
DESCRIPTION
This field displays the reason the log message was generated. The text "[count=x]",
where x is a number, appears at the end of the Message field if log consolidation is
turned on and multiple entries were aggregated to generate into this one.
This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in
this filter.
This displays when you show the filter. Type the source interface of the incoming
packet that generated the log message.
This displays when you show the filter. Type the interface of the destination of the
incoming packet when the log message was generated.
This displays when you show the filter. Select a service protocol whose log
messages you would like to see.
This displays when you show the filter. Click this button to update the log using the
current filter settings.
Click this button to send log message(s) to the Active e-mail address(es) specified
in the Send Log To field on the Log Settings page.
Click this button to update the information in the screen.
Click this button to clear the whole log, regardless of what is currently displayed on
the screen.
This field is a sequential value, and it is not associated with a specific log message.
This field displays the time the log message was recorded.
This field displays the priority of the log message. It has the same range of values
as the Priority field above.
This field displays the source IP address and the port number in the event that
generated the log message.
This field displays the destination IP address and the port number of the event that
generated the log message.
This field displays any additional information about the log message.
ZyWALL/USG Series User's Guide
230