ZyXEL Communications USG40 User Manual page 60

Table 12 USG2200-VPN LED Descriptions (continued)
LED COLOR STATUS
P5-P16 Green Off
(WAN/
On
LAN))
Blinking
Orange Off
On
Blinking
P17-P18 Blue Off
(SFP+)
On
Link
P17-P18 Green Off
(SFP+)
Blinking
ACT
P17-P18 Blue Off
(10GE)
On
Link
P17-P18 Green Off
(10GE)
Blinking
ACT
The following table describes the ports on the front panel.
Table 13 Front Panel Ports
LABEL DESCRIPTION
RESET Press the button in for about 5 seconds (or until the SYS LED starts to blink), then release
it to return the ZyWALL/USG to the factory defaults (password is 1234, LAN IP address
192.168.1.1 etc.)
CONSOLE You can use the console port to manage the ZyWALL/USG using CLI commands. You will be
prompted to enter your user name and password. See the Command Reference Guide for
more information about the CLI.
When configuring using the console port, you need a computer equipped with
communications software configured to the following parameters:
• Speed 115200 bps
• Data Bits 8
• Parity None
• Stop Bit 1
• Flow Control Off
USB Connect a storage device for system logs (see Maintenance > Diagnostics > System
Log) and storage (see Configuration > System > USB Storage).
P1 ~ P6 These are 1G RJ-45 Ethernet ports.
The following table describes the ports on the USG2200-VPN front panel.
Table 14 USG2200-VPN Front Panel Ports
LABEL DESCRIPTION
RESET Press the button in for about 5 seconds (or until the SYS LED starts to blink), then release
it to return the ZyWALL/USG to the factory defaults (password is 1234, LAN IP address
192.168.1.1 etc.)
BUZZER RESET The buzzer alarms when a power module fails. Use this to mute the buzzer alarm.
Chapter 3 Hardware, Interfaces and Zones
DESCRIPTION
There is no connection on this port.
This port has a successful 10/100Mbps link.
The ZyWALL/USG is sending or receiving packets on this port.
There is no connection on this port.
This port has a successful 1000Mbps link.
The ZyWALL/USG is sending or receiving packets on this port.
There is no connection on this port.
This port has a successful 10Gbps link.
There is no traffic on this port.
The ZyWALL/USG is sending or receiving packets on this port.
There is no connection on this port.
This port has a successful 10Gbps link.
There is no traffic on this port.
The ZyWALL/USG is sending or receiving packets on this port.
ZyWALL/USG Series User's Guide
60