Enable Web Authentication - ZyXEL Communications USG40 User Manual

Figure 325 Configuration > Web Authentication > SSO
The following table gives an overview of the objects you can configure.
Table 166 Configuration > Web Authentication > SSO
LABEL
Listen Port
Agent PreShareKey
Primary Agent Address
Primary Agent Port
Secondary Agent Address
(Optional)
Secondary Agent Port
(Optional)
Apply
Reset

20.4.3 Enable Web Authentication

Enable Web Authentication and add a web authentication policy.
Chapter 20 Web Authentication
DESCRIPTION
The default agent listening port is 2158. If you change it on the ZyWALL/USG,
then change it to the same number in the Gateway Port field on the SSO agent
too. Type a number ranging from 1025 to 65535.
Type 8-32 printable ASCII characters or exactly 32 hex characters (0-9; a-f).
The Agent PreShareKey is used to encrypt communications between the
ZyWALL/USG and the SSO agent.
Type the IPv4 address of the SSO agent. The ZyWALL/USG and the SSO agent
must be in the same domain and be able to communicate with each other.
Type the same port number here as in the Agent Listening Port field on the
SSO agent. Type a number ranging from 1025 to 65535.
Type the IPv4 address of the backup SSO agent if there is one. The ZyWALL/USG
and the backup SSO agent must be in the same domain and be able to
communicate with each other.
Type the same port number here as in the Agent Listening Port field on the
backup SSO agent if there is one. Type a number ranging from 1025 to 65535.
Click this button to save your changes to the ZyWALL/USG.
Click this button to return the screen to its last-saved settings
ZyWALL/USG Series User's Guide
453