View Ap Log - ZyXEL Communications ZyWall 110 User Manual

Table 69 Monitor > Log > View Log (continued)
LABEL
Refresh
Clear Log
#
Time
Priority
Category
Message
Source
Destination
Protocol
Search
Priority
Source
Destination
Note

6.24.2 View AP Log

Click on Monitor > Log > View AP Log to open the following screen.
Chapter 6 Monitor
DESCRIPTION
Click this button to update the information in the screen.
Click this button to clear the whole log, regardless of what is currently displayed on
the screen.
This field is a sequential value, and it is not associated with a specific log message.
This field displays the time the log message was recorded.
This displays when you show the filter. Select the priority of log messages to
display. The log displays the log messages with this priority or higher. Choices are:
any, emerg, alert, crit, error, warn, notice, and info, from highest priority to
lowest priority. This field is read-only if the Category is Debug Log.
This field displays the log that generated the log message. It is the same value used
in the Display and (other) Category fields.
This field displays the reason the log message was generated. The text "[count=x]",
where x is a number, appears at the end of the Message field if log consolidation is
turned on and multiple entries were aggregated to generate into this one.
This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in
this filter.
This displays when you show the filter. Select a service protocol whose log
messages you would like to see.
This displays when you show the filter. Click this button to update the log using the
current filter settings.
This field displays the priority of the log message. It has the same range of values
as the Priority field above.
This field displays the source IP address and the port number in the event that
generated the log message.
This field displays the destination IP address and the port number of the event that
generated the log message.
This field displays any additional information about the log message.
ZyWALL/USG Series User's Guide
153