Installation; Flat Mount; Panic Button (Part #Sv-4100-Panic) - Safety Vision OBSERVER 4100 User Manual

Installation

Flat Mount

Secure the MDVR to the surface with self-
tapping screws or rivets.
Ensure that the front panel of the MDVR
remains accessible and there is a minimum
2.5 inches of clearance for cables.. Do not
install the Observer 4100 in an area of the
vehicle cabin that could interfere with the safe
operation of the vehicle.

Panic Button (Part #SV-4100-PANIC)

An optional panic button module is available.
The panic button provides an additional status
LED display, remote control sensor, and external
monitor output in addition to the panic button.
When the panic button module is installed,
ensure the following settings are configured
properly:
1.
In the Settings menu, select Peripheral,
then Ext. Com. Setup. Select PANIC
BUTTON in COM4.
2.
Ensure the panic button module is
connected to the 485A-2 and 485B-2
terminals.
3.
In the Settings menu, select Event, then
"Emergency Alarm" (Alarm of Panic Button
screen). Select ON in the EN (enable) and ALARM fields.
4.
Ensure the module is connected to ground and 5V.
OBSERVER 4100 USER GUIDE
5