7
OBSERVER
™
4816 HVR HARDWARE USER GUIDE
Installation
Security Cover
After connecting all needed cables to the rear of the NVR as shown in the wiring diagram (see page 5), snap the security cover into
place and secure it using the included security Torx screws.
Flat Mount
Secure the NVR to the surface with four (4) #10 machine screws with nyloc nuts, self-tapping screws, or rivets.
Ensure that the front panel of the NVR remains accessible and there is a minimum 2.5 inches of clearance for cables.
Do not install the NVR in an area of the vehicle cabin that could interfere with the safe operation of the vehicle.