Table of Contents
Advertisement
5
ICOP PRO HD Hybrid
Video Recorder
Installation
Console Mount
The ICOP PRO HD HVR can be installed in any
standard console with an available single DIN
slot.
1.
Thread the HVR cable pigtails through the
console mount and slide it up from the back
as shown.
Do not attempt to remove the HVR faceplate.
2. Secure the mount with the two supplied
Phillips head screws, one on each side.
3. Make all necessary wire connections.
4. Slide the HVR into the DIN slot and secure
the mount with four appropriate screws.
Flat Mount
1.
Place the supplied L-brackets on each side
of the HVR, oriented up or down, depending
on the intended installation.
2. Secure the L-brackets to the side of the HVR
with two supplied Phillips head screws each.
3. Secure the HVR assembly to a flat surface
with self-tapping screws or rivets.
Ensure a minimum of 1/2 inch clearance at the rear
of the unit for the fan to provide adequate cooling.
Ensure that the front panel of the HVR remains
accessible and there is a minimum 2.5 inches of
clearance for cables. Do not install the HVR in an
area of the vehicle cabin that could interfere with
the safe operation of the vehicle.
ICOP PRO HD HVR USER GUIDE
Advertisement
Table of Contents
