Avaya Scopia XT7100 Deployment Manual page 98

Initial Configuration of the XT Series
Table 19: Configuring general monitor settings
Field Description
Name
Number of
Activate the HDMI ports on the XT Codec Unit which connect to a monitor: the HD1
monitors
and/or the HD2
• <auto > indicates the system automatically detects the number of connected monitors
(recommended).
• HD1/HD2 forces the unit to accept input only from a single monitor connected to either HD1
or HD2
Duplicate to HD2.
• HD1 (Menu & Video Rx) + HD2 (Present) uses both monitor connections, where the main
monitor displays system menus and remote video, while shared content is on the auxiliary
monitor. This is the default mode with two connected monitors set to <auto > .
• HD1 (Menu & Present) + HD2 (Video Rx) uses both monitor connections, with system menus
and PC content on the main monitor, while remote video is on the auxiliary monitor.
• HD1 (Present) + HD2 (Menu & Video Rx) uses both monitor connections, with system menus
and remote video on the auxiliary monitor, while shared content is on the main monitor.
• HD1 (Video Rx) + HD2 (Menu & Present) uses both monitor connections, with system menus
and shared content on the auxiliary monitor, while remote video is on the main monitor.
Resolution
Defines the resolution of the connected main monitor (HD1
HD1/HD2
).
• <auto > sets 1080p as the default settings for both monitors.
• 1080p forces 1080p resolution at 25, 30, 50 or 60 frames per second (fps) if the monitor
supports it.
• 720p forces 720p resolution at 50 or 60fps if the monitor supports it, even if the received
resolution is higher.
®
Avaya Scopia XT Series Deployment Guide
98
port.
Figure 66: Dual monitor video layouts with presentation
. If you connect a second monitor it would appear blank, unless you select
Comments? infodev@avaya.com
) and auxiliary monitor (HD2
Table continues...
port
April 2015