Avaya Scopia XT7100 Deployment Manual page 117

If you deployed TLS with a security certificate for this device, a change in the IP address requires
creating a new certificate (see
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. Access the advanced network settings. From the XT Series web interface, select
Administrator Settings > Networks > Preferences > General. From the endpoint's main
menu, select Configure > Network.
2. Set the Use IPv6 field to enable or disable IPv6 support.
3. From the web interface only, select Save.
4. Access the IP address. From the endpoint's main menu, select either GLAN 1 or GLAN 2.
From the XT Series web interface, select GLAN 1 or GLAN 2 > Addresses.
5. Enter the following fields:
April 2015
Securing Connections to the XT Series Using TLS
Figure 80: Enabling IPv6 mode
Figure 81: Configuring IP addresses from the web interface
Comments? infodev@avaya.com
Configuring Advanced Network Settings
on page 112.
®
Avaya Scopia XT Series Deployment Guide
on page 160).
117