Avaya Scopia XT7100 Deployment Manual page 154

Advanced Configuration of the XT Series
• Enable remote upgrades and PCs allowed remote access as described in
Securing Remote Upgrades
remote access to specific PCs.
• Download the update, or contact your local customer service representative.
Procedure
1. Verify the XT Series is connected to the network on the GLAN1
Verify the computer can reach the XT Series, and that a firewall does not block TCP port
55099.
2. Download the upgrade package (for example, XT5000_Vxxx.exe) from the Avaya site to the
computer.
This can be used to upgrade any Avaya Scopia
3. On the computer, launch the upgrade file.
4. Enter the IP address of the XT Series in the start screen and select Start.
The upgrade is transferred to the XT Series.
Caution:
After download begins do not shut down the XT Series until download is completed. At
the end of the update, the system reboots automatically.
5. The upgrade procedure may automatically continue after the reboot, and therefore reboot
again. Wait a few minutes to ensure that the upgrade procedure is completed.
Do not turn off the XT Series before the upgrade procedure is completed.
Related Links
Updating the XT Series
®
Avaya Scopia XT Series Deployment Guide
154
on page 159. Be sure to use an allowed computer if you restricted
Figure 107: GLAN1 port
Figure 108: Upgrading the firmware of the XT Series
on page 153
Comments? infodev@avaya.com
port.
®
XT Series.
Enabling and
April 2015