Avaya Scopia XT7100 Deployment Manual page 152

Advanced Configuration of the XT Series
2. Set the fields as required.
Table 47: Configuring SNMP settings
Field Name
SNMP management
Administrator name
Location
Community
Enable all addresses
Address
Subnet mask
3. From the web interface only, select Save.
Related Links
®
Avaya Scopia XT Series Deployment Guide
152
Figure 106: Configuring SNMP settings
Description
Select Yes to enable sending of SNMP messages to an SNMP server.
(Optional) Enter a contact name for this device which would appear in an
SNMP browser.
(Optional) Enter the location of the device, which would appear in an
SNMP browser.
Enter the name of the SNMP community that supports the read and write
operations of SNMP management. Scopia
name to communicate with the gateway in the SNMP Get/Set Community
fields.
The community values are case-sensitive. Typically there is a separate
community for read (GET) called public and a community for write (SET)
called private.
Select No to restrict AT remote access to specific computers in the range
of the Address and Subnet Mask fields below.
Enter the IP address of computers allowed to remotely control the unit with
AT commands.
Enter the Subnet mask to modify the Address field into a range of
addresses allowed to send the unit AT commands.
Comments? infodev@avaya.com
®
Management requires the
April 2015