Avaya Scopia XT7100 Deployment Manual page 125

Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. Access the gatekeeper settings. From the XT Series web interface, select Administrator
Settings > Protocols > H.323 > General. From the endpoint's main menu, select
Configure > Advanced > Protocols > H.323.
2. Set the fields as described in
Table 33: Configuring H.323 settings
Field Name
H.323 Name
E.164
Refuse calls by IP Address
3. From the web interface only, select Save.
4. Select H.323 > Gatekeeper.
April 2015
Figure 86: Configuring H.323 settings from the web interface
Table 33: Configuring H.323 settings
Description
Enter the H.323 alias of this endpoint, used to register the unit with
the gatekeeper. In H.323 calls, this name is displayed on
participant's monitors (for example: John-Smith, or 9th-Floor-Room,
or NY-Office).
Enter this endpoint's E.164 dial number.
Select Yes to allow only endpoints registered to the gatekeeper to
call your endpoint, using your alias or dial number.
Comments? infodev@avaya.com
Configuring Advanced Network Settings
on page 112.
®
Avaya Scopia XT Series Deployment Guide
on page 125.
125