Configuring The Icmp Template; Configuring The Dns Template - HP 5920 Configuration Manual

Some operation parameters for an NQA template can be specified by the template configuration or the
feature that uses the template. When both are specified, the parameters in the template configuration
take effect.

Configuring the ICMP template

A feature that uses the ICMP template creates and starts the ICMP operation to measure the reachability
of a destination device. The ICMP template is supported in both IPv4 and IPv6 networks.
To configure the ICMP template:
Step
1. Enter system view.
2. Create an ICMP template and
enter its view.
3. (Optional.) Specify the
destination IPv4 or IPv6
address of the operation.
4. (Optional.) Specify the
payload size in each ICMP
request.
5. (Optional.) Specify the string
to be filled in the payload of
each request.
6. (Optional.) Specify the IP
address of the specified
interface as the source IP
address of ICMP echo
requests.
7. (Optional.) Specify the source
IPv4 or IPv6 address for the
probe packets.

Configuring the DNS template

A feature that uses the DNS template creates and starts the DNS operation to determine the status of the
server. It is supported in both IPv4 and IPv6 networks.
Command
system-view
nqa template icmp name
•
IPv4 address:
destination ip ip-address
•
IPv6 address:
destination ipv6
ipv6-address
data-size size
data-fill string
source interface interface-type
interface-number
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6 ipv6-address
141
Remarks
N/A
N/A
By default, no destination IP address
is configured.
The default setting is 100 bytes.
The default setting is the
hexadecimal number
00010203040506070809.
By default, no source IP address is
specified. The requests use the
primary IP address of the outgoing
interface as their source IP address.
If you configure both source ip and
source interface, the most recent
configuration takes effect.
The specified source interface must
be up. The source IP address must be
the IP address of a local interface
and the interface must be up.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.