Http Operation Configuration Example - HP 5920 Configuration Manual

Min/Max/Average round trip time: 173/173/173
Square-Sum of round trip time: 29929
Last succeeded probe time: 2011-11-22 10:07:28.6
Extended results:
Packet loss ratio: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to internal error: 0
Failures due to other errors: 0
# Display the history records of the FTP operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index
1
The output shows that Device A uses 173 milliseconds to upload a file to the FTP server.

HTTP operation configuration example

Network requirements
As shown in
data from the HTTP server.
Figure 45 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not
shown.)
# Create an HTTP operation.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type http
# Specify the URL of the HTTP server.
[DeviceA-nqa-admin-test-http] url http://10.2.2.2/index.htm
# Configure the HTTP operation to get data from the HTTP server. (The default HTTP operation type is get,
and this step can be omitted.)
[DeviceA-nqa-admin-test1-http] operation get
# Configure the operation to use HTTP version 1.0. (Version 1.0 is the default version, and this step can
be omitted.)
[DeviceA-nqa-admin-test1-http] version v1.0
Response Status
173 Succeeded
Figure 45, configure an HTTP operation on the NQA client to test the time required to obtain
Time
2011-11-22 10:07:28.6
152