Configuring Layer 2 Remote Port Mirroring - HP 5920 Configuration Manual

A remote probe VLAN must be a static VLAN. To delete this static VLAN, you must first remove the
•
remote probe VLAN configuration by using the undo mirroring-group remote-probe vlan
command.
• If the remote probe VLAN of a remote mirroring group is removed, the remote mirroring group will
become invalid.
Configuration procedure
To configure local port mirroring with multiple monitor ports:
Step
1. Enter system view.
2. Create a remote source
group.
3. Configure source ports
for the remote source
group.
4. Configure the reflector
port for the remote
source group.
5. Create a VLAN to be
configured as the
remote probe VLAN.
6. Assign monitor ports to
the VLAN.
7. Return to system view.
8. Configure the VLAN as
the remote probe VLAN
for the remote source
group.

Configuring Layer 2 remote port mirroring

Configuring Layer 2 remote port mirroring is to configure remote mirroring groups. When doing this,
configure a remote source group on the source device and a cooperating remote destination group on
the destination device. If intermediate devices exist, configure the intermediate devices to allow the
remote probe VLAN to pass through.
Command
system-view
mirroring-group group-id
remote-source
•
In system view:
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
•
In interface view:
a. Enter interface view:
interface interface-type
interface-number
b. Assign the port to the mirroring
group as a source port:
mirroring-group group-id
mirroring-port { both |
inbound | outbound }
c. Return to system view:
quit
mirroring-group group-id reflector-port
reflector-port
vlan vlan-id
port interface-list
quit
mirroring-group group-id
remote-probe vlan rprobe-vlan-id
178
Remarks
N/A
By default, no mirroring groups exist
on a device.
By default, no source port is
configured for a mirroring group.
By default, no reflector port is
configured for a mirroring group.
By default, only VLAN 1 (system
default VLAN) exists.
By default, all ports are in VLAN 1.
N/A
By default, no remote probe VLAN is
configured for a mirroring group.