HP 5920 Configuration Manual page 288

Operation Description
Executes CLI operations. A
request message encloses
commands in the <CLI>
element, and a response
message encloses the command
output in the <CLI> element.
NETCONF supports the
CLI
following views:
•
•
To execute a command in other
views, specify the command for
entering the specified view, and
then the desired command.
Saves the running configuration.
You can use the <file> element
to specify a file for saving the
configuration. If the <file>
save
element does not exist, the
running configuration is
automatically saved to the main
next-startup configuration file.
Loads the configuration. After
the device finishes the load
operation, the configuration in
load
the specified file is merged into
the current configuration of the
device.
Rolls back the configuration. To
do so, you must specify the
configuration file in the <file>
element. After the device
rollback finishes the rollback operation,
the current device configuration
is totally replaced with the
configuration in the specified
configuration file.
Execution—User view.
Configuration—System view.
278
XML example
To execute the display this command in system view:
<rpc message-id="101"
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
<CLI>
<Configuration>display
this</Configuration>
</CLI>
</rpc>
To save the running configuration to the file test.cfg:
<rpc message-id="101"
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0"> <save>
<file>test.cfg</file>
</save>
</rpc>
To merge the configuration in the file a1.cfg to the
current configuration of the device:
<rpc message-id="101"
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0"> <load>
<file>a1.cfg</file>
</load>
</rpc>
To roll back the current configuration to the
configuration in the file 1A.cfg:
<rpc message-id="101"
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
<rollback>
<file>1A.cfg</file>
</rollback>
</rpc>