Verifying The Configuration; Layer 2 Remote Port Mirroring Configuration Example; Network Requirements; Configuration Procedure - HP 5920 Configuration Manual

[Device-Ten-GigabitEthernet1/0/3] quit

Verifying the configuration

# Display information about all mirroring groups.
[Device] display mirroring-group all
Mirroring group 1:
Type: Local
Status: Active
Mirroring port:
Ten-GigabitEthernet1/0/1
Ten-GigabitEthernet1/0/2
Monitor port: Ten-GigabitEthernet1/0/3
Layer 2 remote port mirroring configuration
example

Network requirements

As shown in
bidirectional traffic of the Marketing department.
Figure 63 Network diagram
Source
device
Device A
Marketing
Dept.

Configuration procedure

Configuring Device C (the destination device)
# Configure Ten-GigabitEthernet 1/0/1 as a trunk port to permit the packets of VLAN 2 to pass through.
<DeviceC> system-view
[DeviceC] interface ten-gigabitethernet 1/0/1
[DeviceC-Ten-GigabitEthernet1/0/1] port link-type trunk
[DeviceC-Ten-GigabitEthernet1/0/1] port trunk permit vlan 2
Figure 63, configure Layer 2 remote port mirroring so the server can monitor the
Intermediate
Device B
XGE1/0/2 XGE1/0/1
VLAN 2
XGE1/0/1
Common port Source port
Both
Both
device
XGE1/0/2 XGE1/0/1
VLAN 2
XGE1/0/2
Egress port
187
Destination
device
Device C
Server
Monitor port