Configuring The Ftp Operation - HP 5920 Configuration Manual

Step
2. Create an NQA operation
and enter NQA operation
view.
3. Specify the DNS type and
enter its view.
4. Specify the IP address of the
DNS server as the destination
address of DNS packets.
5. Specify the domain name
that needs to be translated.

Configuring the FTP operation

The FTP operation measures the time for the NQA client to transfer a file to or download a file from an
FTP server.
Follow these guidelines when you configure the FTP operation:
When you perform the put operation with the filename command configured, make sure the file
•
exists on the NQA client.
• If you get a file from the FTP server, make sure the file specified in the URL exists on the FTP server.
The NQA client does not save the file obtained from the FTP server.
•
Use a small file for the FTP operation. A big file might result in transfer failure because of timeout,
•
or might affect other services for occupying much network bandwidth.
To configure the FTP operation:
Step
1. Enter system view.
2. Create an NQA operation
and enter NQA operation
view.
3. Specify the FTP type and
enter its view.
4. Specify the URL of the
destination FTP server.
5. (Optional.) Specify the
source IP address of FTP
request packets.
Command
nqa entry admin-name operation-tag
type dns
destination ip ip-address
resolve-target domain-name
Command
system-view
nqa entry admin-name
operation-tag
type ftp
url url
source ip ip-address
125
Remarks
By default, no NQA operation is
created.
N/A
By default, no destination IP
address is specified.
By default, no domain name is
specified.
Remarks
N/A
By default, no NQA operation is created.
N/A
Enter URL in one of the following formats:
•
ftp://host/filename.
•
ftp://host:port/filename.
When you perform the get operation, the
file name is required.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no FTP
requests can be sent out.