Table of Contents
Advertisement
2BC/D
1-6-5 Drum section
(1) Detaching and refitting the drum
Follow the procedure below to replace the drum.
Cautions
• Avoid direct sunlight or strong light when detaching and refitting the drum.
• Hold the drum at the ends and never touch the drum surface.
Procedure
1. Remove the developing unit (see page 1-6-
44).
2. Remove the main charger unit (see page 1-6-
39).
3. Loosen the blade securing pin, slide the
blade release lever in the direction indicated
by the arrow and tighten the blade securing
pin.
4. Remove the one screw each from the drum
front and rear retainers and then the drum
from the image formation unit.
1-6-42
Blade securing pin
Blade release lever
Figure 1-6-75
Drum front retainer
Drum rear retainer
Drum
Figure 1-6-76
Advertisement
Table of Contents
