Table of Contents
Advertisement
Problem
Causes/check procedures
(15)
Check if the upper and
A paper jam in the
lower feed rollers contact
fixing section is indi-
each other.
cated during copy-
Check if the fixing unit
ing (jam in fixing
front guide is deformed.
section).
Jam code 40
Check if the press roller is
extremely dirty or de-
formed.
Check if the heat roller
separation claws are dirty
or deformed.
Check if the heat roller and
its separation claws con-
tact each other.
Broken eject switch actua-
tor.
Defective eject switch.
(16)
Check if the eject roller
A paper jam in the
and eject pulley contact
eject section is indi-
each other.
cated during copy-
Broken eject switch actua-
ing (jam in eject
tor.
section).
Jam code 50
Defective eject switch.
(17)
Defective face down eject
A paper jam in the
switch.
eject section is indi-
cated during copy-
ing (jam in face
Check if the left or right
down eject section).
face down feed roller is
Jam code 51
deformed.
Check if the right middle or
left face down eject guide
is deformed.
(18)
Broken feedshift switch
A paper jam in the
actuator.
feedshift section is
Defective feedshift switch.
indicated during
copying (jam in
feedshift section).
Jam code 52/53
Corrective measures
Check visually and remedy if necessary.
Repair or replace if necessary.
Clean or replace if necessary.
Clean or replace if necessary.
Remedy if the separation claw springs are out of place.
Check visually and replace the eject switch if its actuator is bro-
ken.
Run maintenance item U031 and turn the eject switch on and off
manually. Replace the eject switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Check visually and remedy if necessary.
Check visually and replace the eject switch if its actuator is bro-
ken.
Run maintenance item U031 and turn the eject switch on and off
manually. Replace the eject switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the face down eject switch
on and off manually. Replace the face down eject switch if indi-
cation of the corresponding switch on the touch panel is not dis-
played in reverse.
Check visually and replace any deformed rollers.
Repair or replace if necessary.
Check visually and replace the feedshift switch if its actuator is
broken.
Run maintenance item U031 and turn the feedshift switch on
and off manually. Replace the feedshift switch if indication of the
corresponding switch on the touch panel is not displayed in re-
verse.
2BC/D
1-5-15
Advertisement
Table of Contents
