Kyocera Ri 4530 Copystar Service Manual page 51

16. Fit the main tray with two hexagonal nuts.
17. Secure the main tray with two pins.
18. Attach the sub tray to the finisher by inserting
the projections at the front and back of the
sub tray into the holes of the finisher. (For the
multi finisher only)
19. Attach label A to the recessed portion on the
side of the main tray.
20. Attach label B to the recessed portion on the
side of the sub tray. (For the multi finisher
only)
Main tray
Label A
21. Connect the signal cable of the finisher to the
connector of the copier.
22. Plug the copier's power cable into a wall
outlet and turn the copier on from the main
switch.
Hexagonal nuts
Pins
Label B
Figure 1-3-46
Figure 1-3-47
2BC/D
Sub tray
Projection
Hole
Projection
Hole
Signal cable
1-3-23