Kyocera Ri 4530 Copystar Service Manual page 212

2BC/D
• Removing the upper paper feed pulley
4. Remove the four screws holding the deck
conveying unit and then the unit from the
machine.
5. Remove the stop ring and then the gear.
6. Remove the two stop rings and disconnect
the connector, and then remove the wire of
the paper feed clutch from the wire saddle.
7. Pull the upper paper feed shaft in the
direction of the arrow, and then remove the
upper paper feed pulley.
* When fitting the upper paper feed pulley, put
the end face with a silver ring to the front side
of the machine.
* When fitting the upper paper feed shaft,
ensure that the notch of the paper feed clutch
is inserted into the detent.
1-6-8
Deck conveying unit
Figure 1-6-15
Stop ring
Gear
Figure 1-6-16
Stop rings
Upper paper feed shaft
Upper paper feed pulley
Figure 1-6-17
Connector
Wire saddle