Transfer And Separation Section - Kyocera Ri 4530 Copystar Service Manual

2BC/D-1

1-6-7 Transfer and separation section

(1) Detaching and refitting the charger wires and cleaning pads
Follow the procedure below when the charger wires and cleaning pads is broken or to be replaced.
Precautions
• Carry out replacement after running maintenance item U923 (Checking/clearing the transfer charger cleaning counter)
to clear the counter.
• Use the specified tungsten wire for the charger wire.
• The part of the wire wrapped around the charger spring must not protrude from the charger housing.
• The cut end of the charger wire must not protrude from under the charger wire retainer pin.
• Use a clean, undamaged tungsten charger wire.
• Keep the charger wire taut by stretching the charger spring.
• Clean the transfer charger shield when replacing the charger wire.
* Do not use organic solvents such as alcohol and thinner to clean the transfer charger shield.
Procedure
1. Open the front cover, tilt the paper conveying
unit release lever down, and pull out the
paper conveying unit.
2. Remove the connector, widen the
engagement portions a little, and remove the
transfer unit from the paper conveying unit.
1-6-48
Transfer charger unit
Connector
Engagement portions
Figure 1-6-87
Engagement portions