Kyocera Ri 4530 Copystar Service Manual page 97

2BC/D-1
Maintenance
item No.
U102 Setting the cleaning interval for the main charger
Description
Executes a cleaning operation for the main charger and changes the intervals at which the main charger is
cleaned.
Purpose
To check the cleaning operation for the main charger. Also to change the intervals for the operation. Making the
intervals longer decreases the stand-by time when starting copying.
Method
Press the start key. The screen for selecting an item is displayed.
Display
MC ADJUST DATA
MC TEST RUN
Setting
1. Change the setting using the ∗ or # keys.
Setting range: 1 to 2 (unit: 1,000 sheets)
Initial setting: 2
If you select MC TEST RUN, the main charger cleaning operation will be performed once.
2. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U110 Checking/clearing the drum count
Description
Displays the drum counts for checking, clearing or changing the figure, which is used as a reference when
correcting the main charger potential output.
Purpose
To check the drum status. Also used to clear the count after replacing the drum during regular maintenance.
Since the count was cleared before shipping, do not clear it when installing.
Method
Press the start key. The drum counter count is displayed.
Clearing
1. Press the CLEAR on the touch panel.
2. Press the start key. The count is cleared, and the screen for selecting a maintenance item No. is displayed.
Setting
1. Enter a six-digit count using the numeric keys.
2. Press the start key. The count is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit the maintenance mode without changing the count, press the stop/clear key. The screen for selecting a
maintenance item No. is displayed.
1-4-32
Description
Description
Main charger cleaning operation intervals
Main charger cleaning operation ON